Brother AX-10 - Manual (Page 8)

CORRECTION TAPE
Take-up spool
Feed spool
Both lift-off correctable ribbon correction tape and
cover-up nylon correction tape are available. The lift-off
tape removes the character from the paper and the
cover-up tape leaves the character on the paper but
covers it with white ink.
To replace the correction tape, first remove the cassette
ribbon and then remove the used correction tape. Insert
new correction tape then replace cassette ribbon.
Use the space bar to locate the carrier to the center of
the platen. Open the top cover of the typewriter and
hold a new roll of correction tape so the feed spool is in
your left hand and the take-up spool in your right hand.
The rough side of the tape should be toward the platen.
CASSETTE RIBBON
To insert a cassette ribbon, turn the ribbon feed knob
on the cassette counterclockwise to tighten the ribbon.
Then use both hands to slip the back edge of the
cassette onto the carrier.
CASSETTE
DAISY WHEEL
Pull the green motor lock lever on the carrier toward
you.
Note: Use authorized cassette ribbon and correction tape oniy.
O Faiiure to do so, wiii invaiidate the guarantee.