Brother AX-10 - Manual (Page 17)

INSERTION
Often when we get to the end of a typed page we find a word in which we missed a
letter or doubled a letter. With the half backspace feature of the AX-10, such mistakes
can be corrected while still presenting an overall balanced appearance. The following
correction procedures can be performed either using memory correction or manual
correction.
A s y o u k n o w , B r t h e r t y p e w r i t e r s a r e
In this case, the letter “o” has been omitted from the word
“Brother”, so the simple deletion/correction procedure outlined
on page 15 cannot be done.
1 B r t h e r
--- ------A
(I
+
)
+
First of all, delete the entire
misspelled word, “Brther” using
the manual correction
procedures expiained on page 15.
-A
After you make sure that the carrier is at the position
where the “B” of “Brther” was located, press the
half backspace key.
B r o t h e r
A------------ > A
+M+Kfl+ia+H+ +
Now type in the word “Brother” and you can hardly
tell that a correction was made.
A s y o u k n o w , B r o o t h e r t y p e w r i t e r s a r e
Now we have an example where there are too many letters. Just
deleting and correcting will leave an extra space either before or
after “Brother”, resulting in an unbalanced appearance.
\
B r o o t h e r
-A
(
+
) +
Again, delete the entire
misspelled word.
-A
■/
Now locate the carrier at the position where the
second letter (“r”) of “Broother” was located and press
the half backspace key.
B r o t h e r
A-------------> A
Finally, type in the word “Brother”.
(D