Kenmore ELITE 795.7103 - Manual (Page 41)

Problem Possible Causes Solutions
Not dispensing ice. Not all of the doors are closed completely. Ice will not dispense if any of the refrigerator
doors are left open.
The dispenser display is locked. Press and hold the Lock button for 3 seconds
to unlock the control panel and dispenser.
Ice is not selected on the dispenser. The dispenser can be set for ice or water.
Make certain that the control panel is set for
the proper operation. Press the Ice Select
button on the control panel to cycle through
the ice options.
The ice dispenser is not used often. Infrequent use of the ice dispenser will cause
the cubes to stick together over time, which
will prevent them from properly dispensing.
Check the ice bin for ice cubes clumping/
sticking together. If they are, break up the ice
cubes to allow for proper operation.
Ice bin is not installed correctly. Be sure to correctly install the ice bin into
position. Refer to Using your Refrigerator for
removal and installation instructions.
New installation. Wait 12 to 24 hours after icemaker
installation for ice production to begin. Wait
72 hours for full ice production.
The delivery chute is clogged with frost or ice
fragments.
Eliminate the frost or ice fragments by
removing the ice bin and clearing the chute
with a plastic utensil. Dispensing cubed ice
can also help prevent frost or ice fragment
buildup.
Dispensing warm
water.
New installation. Allow 24 hours after installation for the water
storage tank to cool completely.
The water dispenser has been used recently
and the storage tank was exhausted.
The unit has a 12 oz water storage tank inside
the refrigerator.
The refrigerator is connected to a hot water
line.
Make sure the refrigerator is connected to a
cold water pipe.
Refrigerator or
Freezer section is too
cold.
Controls are not set correctly for conditions. If the temperature is too cold, raise the
temperature setting one increment at a time
(refer to the Setting the Controls section).
When changing control settings, wait 24 hours
before making additional adjustments.
41