Kenmore ELITE 795.7103 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

HOW TO REMOVE THE FREEZER DRAWER HOW TO INSTALL THE FREEZER DRAWER

WARNING:

Use two or more people to remove and

install the freezer drawer.

Failure

to do so can result in

back or other injury.

ACAUTION:

Do not hold the handle when removing or

replacing the drawer. The handle may come

off

and it

could cause personal injury.

NOTE:

In the following figures, the Pullout Drawer

located above the freezer drawer is not shown for

clarity.

Pull the drawer open to full extension. Remove the

lower basket (J) by lifting the basket from the rail

system.

Remove the screws @ of the rail on both sides.

Grasp the drawer on each side and pull it up to

separate it from the rails.

With both hands, hold the center bar and push it in to

allow both rails to slide in simultaneously.

With both hands, hold the center bar and pull it out

until both rails are fully extended.

Grasp the drawer on each side and hook door

supports (T) into rail tabs @ located on both sides.

Lower the door into final position and tighten the

screws (

) located on both sides.

With the drawer pulled out to full extension, insert the

lower basket @ in the rail assembly.

AWARNING:

If the Durábase divider is removed, there is

enough open space for children or pets to crawl inside.

To prevent accidental child and pet entrapment or

suffocation risk, DO NOT allow them to touch or go

near the freezer drawer.

AWARNING:

DO NOT step or sit down on freezer

drawer.