Kenmore 790.4885 - Manual (Page 29)

Wail Oven General Care & Cleaning
(continyed)
Removing and Replacing the Lift-Off Oven Door
with oven door fully open
Fig. 1
5c
Fig. 2
ik CAUTION
I The door is heavy. For safe, temporary storage, lay the door flat with
the inside of the door facing down.
To Remove Oven Door:
1. Open oven door completely (horizontal with floor - See Fig. 1).
2. Pull the door hinge locks on both left and right door hinges down from the oven
frame completely towards the oven door (See Fig. 2). A tool such as a small flat-
blade screwdriver may be required.
3. Firmly grasp both sides of oven door along the door sides (Do not use the oven
door handle - See Fig. 3).
4. Close the door to the broil stop position (the oven door will stop into this position
just before fully closing).
5. With the oven door in the broil stop position, lift the oven door hinge arms over
the roller pins located on each side of the oven frame (See Fig. 4).
To Replace Oven Door:
1
.
2
.
3.
4.
5.
Firmly grasp both sides of oven door along the door sides (Do not use the oven
door handle - See Fig. 3).
Holding the oven door at the same angle as the removal position, seat the hook
of the hinge arm over the roller pins located on each side of the oven door frame|
(See Fig. 4). The hook of the hinge arms must be fully seated onto the roller pini
Fully open the oven door (horizontal with floor - See Fig. 1).
Push the door hinge locks up towards and into the oven frame on both left and -
right oven door hinges (See Fig. 2) to the locked position.
Close the oven door.
Fig. 4
Special Door Care Instructions - Most oven doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks are fully in place.
2. Do not hit the glass with pots, pans, or any other object.
3. Scratching, hitting, jarring or stressing the glass may weaken its structure
causing an increased risk of breakage at a later time.
Changing the Oven Light
On some models an interior oven light will turn automatically when the oven door
o
is opened. The oven light may be turned on when the door is closed by pushing ^
located on the control panel. On some models, the lamp is covered with a glass
shield held in place by a wire holder. THE GLASS SHIELD MUST BE IN PLACE
WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with 40-watt appliance bulb only.
4. For models with glass shield, press holder on one side to release glass shield,
change bulb and be sure to replace the glass shield.
Care and Cleaning of Stainless Steel
(some models)
Some models are equipped with stainless steel exterior parts. Special care and clean­
ing are required for maintaining the appearance of stainless steel parts. Please refer
to the table provided at beginning of this General Care & Cleaning section in this
Use & Care Manual.