Solution, Before you call, Solutions to common problems – Kenmore 790. 7260 User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Before You Call

• Solutions to common problems

Problem

Surface burners do not ignite.

Solution

• Surface control knob was not completely turned to LITE. Push in & turn the

surface control knob to LITE until burner ignites and then turn control knob to

desired flame size.

• Burner ports are clogged. With the burner OFF, use a small-gauge wire or

needle to burner head slots and ignition ports. See

Cleaning the cooktop and

surface burners

in the Care & Cleaning section for additional cleaning

instructions.

• Range power cord is disconnected from outlet (electric ignition models only).

Be sure power cord is securely plugged into the power outlet.

• Electrical power outage. Burners may be lit manually. See section on Setting

Surface Controls.

Surface burner flame only part way

around burner cap.

Burner slots or ports are clogged. With the surface burner OFF, clean ports

with a small-gauge wire or needle.

Moisture is present after cleaning. Lightly fan the flame and allow burner to

operate until flame is full.

•

Surface burner flame is orange.

• Dust particles in main gas line. Allow the burner to operate a few minutes

until flame turns blue. In coastal areas, a slightly orange flame is

unavoidable due to salt content in air.