Solution, Before you call, Solutions to common problems – Kenmore 790. 7260 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/665656/24/background.png)
Before You Call
• Solutions to common problems
Problem
Oven smokes excessively when broiling.
Solution
• Incorrect setting. Follow broiling instructions in Setting Oven Controls
section.
• Be sure oven door closed when broiling.
• Meat too close to upper burner. Reposition the oven rack to provide proper
clearance between the meat & the upper burner. Preheat oven when
searing.
• Meat not properly prepared. Remove excess fat from meat. Cut remaining
fatty edges to prevent curling, but do not cut into lean.
• Grease has built up on oven surfaces. Regular cleaning is necessary when
broiling frequently. Old grease or food spatters cause excessive smoking.
Flames inside oven or smoking from oven
vent.
Select Clean does not work.
Soil not completely removed after
running Select Clean cycle.
Oven racks discolored.
Oven light does not work.
• Excessive spillovers in oven. For example this will happen for pie
spillovers or large amounts of grease left on the oven bottom. Wipe up
excessive spillovers before starting oven. If flames or excessive smoke
are present see
Broil
in Setting Oven Controls section.
• Oven control not set properly. Review instructions in
Select Clean
section.
• Select Clean was interrupted. Review instructions in
Select Clean
section.
• Excessive spillovers on oven bottom. Remove before starting Select Clean.
• Failure to clean soil from the oven frame, the door liner outside the oven
door gasket and the small area at the front center of the oven bottom.
These areas are not in the self-cleaning area, but get hot enough to burn
on residue. Clean these areas before the self-cleaning cycle is started.
Burned-on residue can be cleaned with a stiff nylon brush and water or a
nylon scrubber. Be careful not to damage the oven gasket.
• Oven racks left in oven cavity during Select Clean. Always remove oven
racks from oven cavity before starting a self-clean cycle. Clean by using a
mild, abrasive cleaner following manufacturer's instructions. Rinse with clean
water, dry and replace in oven.
•
• Be sure the oven light is secure in the socket. Also see
Replacing oven light
in the Care & Cleaning section.
24