Grounding instructions, Important safety instructions – Kenmore 790. 7744 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Important Safety Instructions
important Safety Notice
The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of
substances known to the state to cause cancer, birth defects or other reproductive harm, and requires businesses to warn
customers of potential exposure to such substances.
Grounding type
wall receptacle
Do not, under any
circumstance, cut,
remove, or bypass
the grounding prong.
Power supply cord
with 3-prong
grounding plug
Grounding Instructions
(electric ignition models only)
ik WARNING
Avoid fire hazard or electrical shock. Do not use an adapter plug,
an extension cord, or remove grounding prong from electrical power cord. Failure
to follow this warning can cause serious injury, tire or death.
A WARNING
This appliance is equipped with a 3-prong grounding plug tor
your protection against shock hazard and should be plugged directly into a
properly grounded receptacle. DO NOT cut or remove the grounding prong from
this plug.
For personal safety, the range must be properly grounded. For maximum safety,
the power cord must be plugged into an electrical outlet that is correctly polarized
and properly grounded.
It a 2-prong wall receptacle is the only available outlet, it is the personal
responsibility of the consumer to have it replaced with a properly grounded 3-
prong wall receptacle installed by a qualified electrician.
See the INSTALLATION INSTRUCTIONS packaged with this range for complete
installation and grounding instructions.
„/ '
! ’
Conversion to Liquefied Petroleum Gas (or L.P. Gas)
The natural gas range is designed to allow for conversion to
Liquefied Petroleum (L.P.) Gas.
If L.P. conversion is needed, contact your local L.P. gas
providerforassistance. The L.P. Conversion Kit is provided with
this appliance and is located on the left lower REAR (back side)
panel of the range. Before installing the kit be sure to follow the
L.P. Installation Instructions carefully.
ik WARNING
Personal injury or death from electrical
shock may occur if the range is not installed by a
qualified installeror electrician.
ikCAUTION
I Any additions, changes or conversions
required in order for this appliance to satisfactorily meet
the application needs must be made by Sears Service.