beautypg.com

Setting warmer drawer controls (cont’d), To remove warmer drawer, To replace warmer (warm & ready™) drawer – Kenmore 790. 7744 User Manual

Page 17: Setting warmer drawer controls, Cont’d), Ready™)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Setting Warmer Drawer Controls

(cont’d)

To Set the Warmer (Warm &

Ready™)

Drawer Thermostat

Control (some models)

The thermostat control is used to select the temperature of the warmer drawer.

It is located on the control panel (See Fig. 3 on previous page). To set the

thermostat, push in and turn the knob to the desired setting. The temperatures
are approximate, and are designated by HI, MED and LO.

1. Turn the knob to select the desired temperature setting.

2. For best results, preheat the drawer before adding food. An empty drawer

will preheat in approximately 15 minutes.

3. Turn the thermostat control to OFF after use.

Warmer (Warm & Ready™) Drawer Temperature Selection

(some models)

Refer to the table in the side column for recommended settings. If a particular

food is not listed, start with the medium setting. If more crispness is desired,

remove the lid or aluminumfoil.

Most foods can be kept at serving temperatures by using the medium setting.

When a combination of foods are to be kept warm (for instance, a meat with 2
vegetables and rolls), use the high setting.

Refrain from opening the warmer drawer while in use to eliminate loss of heat

from the drawer.

Warmer (Warm & Ready™) Drawer Indicator Light (some models)

The indicator light is located above the Warmer Drawer thermostat control. It turns on when the control is set, and stays on

until the control is turned OFF. The warmer drawer is inoperable during the Self-Clean cycle. The indicator lightwill not
come on during the Self-Clean cycle.

To Remove and Replace Warmer (Warm & Ready‘s“) Drawer (some models)

Warmer Drawer Recommended

Food Settings Table

Food Item

Setting

Bacon

HI

Hamburger Patties

HI

Poultry

HI

Pork Chops

HI

Fried Foods

HI

Pizza

HI

Gravies

MED

Casseroles

MED

Eggs

MED

Roasts (Beef, Pork, Lamb)

MED

Vegetables

MED

Biscuits

MED

Rolls, hard

MED

Pastries

MED

Rolls (soft)

LC

Empty Dinner Plates

LC

Pull up with finger

Push down with finger

Fig. 1

To Remove Warmer Drawer:

i^CAUTION

iTurn power off before removing the warmer drawer.

2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull upon the left glide lever and

push down on the right glide lever (See Fig.1).

5. Pull the drawer away from the range.

To Replace Warmer (Warm & Ready™) Drawer:

1. Pull the bearing glides to the front of the chassis glide (See Fig. 2).

2. Align the glide on each side of the drawer with the glide slots on the range.
3. Push the drawer into the range until levers “click” (approximately 2”). Pull

the drawer open again to seat bearing glides into position. Ifyou do not

hear the levers “click” or the bearing glides do not feel seated
remove the drawer and repeat steps 1 thru 3. This will minimize
possible damage to the bearing glides.

NCTE;The WarmerDrawerwill NOT operate while in the Self-Clean and “Cven
Lockout” modes

WARNING

Electrical Shock Hazard can occur and result in

serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.

Fig. 2

17

This manual is related to the following products: