beautypg.com

To set for broiling, To operate the oven light (some models), Setting oven controls – Kenmore 790.7863 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Setting Oven Controls

(cont d)

To Set for Broiling:

1. Arrange the oven rack while oven is still cool. Position the rack as

suggested in the Broil Rack Position Table below.

2

.

3.

4.

5.

6

.

Press "---------------"will appear in display.

Press and hold the or until the desired broil setting level appears in

the display. Press the >*V for HI broil or the for LO broil. Most foods

may be broiled at the HI broil setting. Select the LO broil setting to avoid

excess browning or drying of foods that should be cooked to the well-done
stage.

For optimum browning, preheat broil burner for 3 - 4 minutes before

adding food.

Place the insert on the broil pan, then place the food on the insert (See
Fig. 1). DO NOT use the broil pan without the insert or cover the insert with

aluminum foil. The exposed fat could ignite.

If needed, arrange oven rack to desired postion. Place the pan on the oven
rack. Close the oven door when broiling.
Broil on one side until food is browned. Turn and broil food on 2nd side.
Note: Always pull the oven rack out to the stop position before turning or
removing the food.

8

.

When broiling is finished, press (S).

Broil Rack Position Table (Refer to Fig. 2)

Rack Postion from Top

Food category

1st rack position

Medium-rare steaks & hamburgers

2nd rack position

Fish, medium steaks & pork chops

3rd rack position

Well-done foods such as chicken & lobster

Note: The broiler pan and the insert allows grease to drain and be kept away

from the high heat of the broiler. DO NOT use the pan without the insert. DO

NOT cover the insert with foil; the exposed grease could ignite.

iSik CAUTION

Should an oven fire occur, close the oven door and turn the oven

OFF. If the fire continues, use a fire extinguisher. DO NOT put water or flour on
the fire. Flour may be explosive.

To Operate the Oven Light (some models)

The interior oven light will automatically turn ON when the oven door is opened.

Press the Oven Light Switch located on the upper left control panel to turn the
interior oven light ON and OFF whenever the oven door is closed (Fig.3).

The interior oven light is located at the upper left rear wall of the oven interior and
is covered with a glass shield held by a wire holder. The glass shield must be in
place wheneverthe oven is in use. Tochange the interioroven light, see "Changing
the Oven Light" in the General Care & Cleaning section.

Fig. 1

■HH

mÊÊÊÊÊm

m

©

3

Fig. 2

13

This manual is related to the following products: