beautypg.com

Removing the old water heater, Awarning, Acaution – Kenmore 153.31614 User Manual

Page 6: Installation instructions

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Removing the Old Water
Heater

Turn “OFF” electrical supply to the water heater.

Installation Instructions

©

a. If you have copper piping to the water

heater, the two copper water pipes can be
cut with a hacksaw approximately 4" away
from where they connect to the water
heater. This will avoid cuttii^ off the pipíes
too short. Additional cuts can be made
later if necessary. Disconnect the tempera­
ture-pressure relief valve drain line, ^^en
the water heater is drained, disconnect the
hose from the drain valve. Close the drain
valve. The water heater is now completely
disconnected and ready to be removed.

^2^

Turn “OFF" the water supply

' ^ water heater at the water shutoff'

water meter.

©

Attach a hose to the water heater drain
valve and put the other end in a floor

drain or outdoors. Open the water
heater drain valve. Open a nearby hot

water faucet which will relieve pressure

in the water heater and speed draining.

©

b. If you have galvanized pipe to the water

heater, loosen the two galvanized pipes
with a pipe wrench at the union in each
line. Also disconnect the piping remaining
to the water heater. These pieces should be
saved since they may be needed when

reconnecting

the

new

water

heater.

Disconnect the temperature-pressure relief

valve drain line. When the water heater is
drained, disconnect the hose from the
drain valve. Close the drain valve. The
water heater is now completely disconnect­
ed and ready to be removed.

AWARNING

The water passing out of the drain valve may be
extremely hot. To avoid being scalded, make sure all con­
nections are tight and that the water flow is directed

away from any person.

©

Check again to make sure the electrical supply is
turned “OFF” to the water heater. Then disconnect
the electrical supply connection from the water
heater junction box.

ACAUTION

Mineral buildup or sediment may have accumulated in

the old water heater. This causes the water heater to be

much heavier than normal and this residue, if spilled out,

could cause staining.

This manual is related to the following products: