Element cleaning, Replacement, Awarning – Kenmore 153.31614 User Manual
Page 19: Service and adjustment (cont'd), Element cleaning/ replacement
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Element Cleaning/
Replacement
NOTE: These instructions are written for element deaning
and element replacement for the lower element. If it is neces
sary to dean or replace the upper dement, then repeat these
instructions.
To remove the element from your tank in order to clean or
replace it;
1. Before beginning turn “OFF” the electric power supply to the
water heater.
Service and Adjustment (cont'd)
4. Remove the two screws securing the access panel, and remove
panel.
^____________ AWARNING_______________
HAZARD
OF
ELECTRICAL
SHOCKl
Before
removing
any access panels or servicing the water heater, make
sure the eiectrical supply to the water heater is turned
“OFF". Failure to do this could result in DEATH, SERI
OUS BODILY INJURy, OR PROPERTY DAMAGE.
2. Turn off the water supply to the water heater at the water
shutoff valve or water meter.
3, Attach a hose to the water heater drain valve and put the
other end in a floor drain or outdoors. Open the water heater
drain valve. Open a nearby hot water faucet which will relieve
pressure in the water heater and speed draining.
AWARNING
The water passing out of the drain valve may be
extremely hot. To avoid being scalded, make sure all con
nections are tight and that the water flow is directed
away from any person.
5. Open the flap of insulation to expose the opening.
6. Lift out the tab as shown to unclip the terminal cover from
the thermostat. The terminal cover can now be removed
from the thermostat.
19