Awarning, Installation instructions (cont’d) – Kenmore 153.31614 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Instructions (cont’d)
NOTE: Whether or not the element conversion is made the
model rating plate must be marked.' Using a hard point ink
pen> check the appropriate block within the model rating
plate, which is located adjacent to the lower access panel.
Necessary element conversion parts are located in a small bag
contained within the electrical junction box on top of the water
heater.
CONVERSION PARTS
2. The convertible element is located behind the lower access
panel of the water heater. Remove the two screws securing
the access panel, and temove panel.
3. Open the flap of insulation to expose the opening.
BUSS BAR
1, Before beginning the conversion turn “OFF” electric power
supply to the water heater.
AWARNING
HAZARD
OF
ELECTRICAL
SHOCK!
Before
removing
any access panels or servicing the water heater, make
sure the electrical supply to the water heater is turned
“OFF”.
FAILURE
TO
DO
THIS
COULD
RESULT
IN
DEATH,
SERIOUS
BODILY
INJURY,
OR
PROPERTY
DAMAGE.
4. Lower Element: Lift out the tab as shown to unclip the ter
minal cover from the thermostat. The terminal cover can be
removed from the thermostat.
11