Materials and basic tools needed, Materials needed, Basic tools – Kenmore 153.31614 User Manual
Page 5: Additional tools needed when sweat soldering
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Materials and Basic Tools Needed
Materials Needed
To simplify the installation Scars has available the installation
parts shown below. You may or may not need all of these materi
als, depending on your type of instdiation.
WATER HEATER HEAT TRAPS
HELP REDUCE HEAT LOSS DUE
TO THERMAL SYPHONING
20" DIAMETER DRAIN PAN
FOR WATER HEATERS 18" IN
DIAMETER AND UNDER
WATER HEATER INSTALLA
TION KIT WITH FLEXIBLE
CONNECTORS FOR 3M" OR
in" THREADED OR COPPER
PLUMBING
EXPANSION TANKS FOR THERMAL
EXPANSION CONDITIONS AVAILABLE
IN 2 GALLON AND 5 GALLON CAPACITY
THROUGH LOCAL SEARS SERVICE
CENTERS
28" DIAMETER DRAIN PAN FOR
WATER HEATERS 26" IN
DIAMETER AND UNDER
Basic Tools
You may or may not need all of these tools, depending on your
type of installation. These tools can be purchased at your local
Sears store.
Pipe Wrench (2)
Screwdriver
6 Foot Tape or Folding Rule
Garden Hose
Drill
Pipe Dope or Teflon Tape
GARDEN HOSE
6 FOOT TAPE
SLOT-HEAD SCREW DRIVER
PHILLIPS SCREWDRIVER
PIPE
WRENCH
PIPE DOPE
(SQUEEZE TUBE)
ROLL OF TEFLON TAPE DRILL
(Use only on water connections)
ADDITIONAL
TOOLS
NEEDED
WHEN SWEAT SOLDERING
Tubing Cutters or Hacksaw
Propane Torch
Soft Solder
Solder Flux
Emery Cloth
Wire Brushes
HACKSAW
fV
\
A
3M" WIRE BRUSH
U2" WIRE BRUSH
ROLL OF LEAD FREE
SOFT SOLDER
PROPANE TORCH
ROLL OF EMERY
CLOTH
SOLDER
FLUX