Know about your water softener, Pressure drop (psi) vs. flow rate (gpm), A. dimensions/specifications – Kenmore 625.38816 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
•j
JJ JJ JJ-
A. DIMENSIONS/SPECIFICATIONS
Pressure Drop (PSI) vs. Flow Rate (GPM)
40 "1
SECTION 4
KNOW ABOUT YOUR WATER SOFTENER
OTHER SPECIFICATIONS UltraSoftlOO
UltraSofttSO
Type of ion exchange material (resin)...................................... high capacity
Amount of resin (cu ft)............................................................... .72
Total regeneration time.............................................................. approximately 118
minutes @ 4.3 salt
dose
Efficiency Rating ....................................................................... 5060 @ 2.2 lb salt
Max. Drain Flow Rate (gpm)...................................................... 1.8
high capacity
.80
approximately 118
minutes @ 4.8 salt
dose
5060 @ 2.4 lb salt
1.8
gpm = gallons per minute gpg = grains per gallon
psi = pounds per square inch ppm = parts per million
This system conforms to NSF/ANS! 44 for the specific performance claims as verified and substantiated by test data.
The efficiency rating is only valid at the stated salt dosage. These softeners were efficiency rated according to NSF/ANSI
Standard 44.
4 - 2
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line