Kenmore 625.38816 - Manual (Page 10)

J J J J J J J J
■J .«4 J vl .J-J-J J J J J J J-M •
SECTION 2 a J J J V.U .j «I ^- n U ^ ^ J
J U ^ J
4
J J J J J-i-t->'J
J J J ^ ^-J
4
J •«-J-t J >J
HOW YOUR WATER SOFTENER WORKS
A. FACEPLATE TIMER FEATURES
IJJJJJJJJJJJJJJJJJ
IJJJJjJJJJJJJJJJJJ IJJJJ^JJJJJJJJJJJ
I jjJVjSjJjjjjjJjj
IJJJJJ Jjjjjjjjjjj
IJJJJ^^JJJJJJJJJJ iJjjJKJjjjjjjjjjjJ
ijj^BîMj jjjjjj JJ J
ijj Jnnjjjjjjjj JJ
IJJJJJJJJJJJJJJJJJ
JJJJJJJJJJJJJJJJJ.
JJJJJJJJJJJJJJJJJ
^ EXTRA RECHARGE
Sometimes, a manually started
regeneration (recharge) may be
desired, or needed. Two exam­
ples are:
' You have used more water than
usual (guests visiting) and you
may run out of soft water before
the next timer started regenera­
tion.
- You did not refill the softener
with salt before it was gone. After
you refill with salt;
You can start a regeneration right
away, or you can set the timer to
regenerate at the next 2:00 AM (or
other preset recharge time). Do
the following.
3 .
13
• ir
iC'^
RECHARGE NOW
^ RECHARGE NOW
Press the ON/OFF-HOLD but­
ton and hold for 3 seconds. RE­
CHARGE NOW begins to flash
in the display, and the softener
enters the fill cycle of regeneration right away. This
regeneration will last for about 2 hours. Then, you
wül have soft water again.
► RECHARGE TONIGHT
3 - O
• It'
RECHARGE TONIGHT
Press and release (do not hold) the
ON / OFF-HOLD button. RE­
CHARGE TONIGHT flashes in
the display, and the softener be­
gins regeneration at the next preset recharge time.
Press and release the ON/OFF-HOLD button once
more if you decide to cancel the regeneration, and
RECHARGE TONIGHT
^ PROGRAM MEMORY
If electrical power to the softener goes off, the time
display is blank but the face plate timer keeps the
correct time for about 6 hours. When electrical pow­
er comes on again, you have to reset the present
time only if the display is flashing. The HARDNESS
and RECHARGE TIME never require resetting un­
less a change is desired. Even if the timer is incorrect
after a long power outage, the softener works as it
should to keep your water soft. However, regenera­
tions may occur at the wrong time of day until you
reset the timer to the correct time of day.
^ ERROR CODE
An error code could appear in
the face plate display if a prob­
lem occurs in the softener elec­
tronics. If you see an error code
instead of the present time of
day, turn to page 5-2 under
"Troubleshooting" to resolve
the problem.
err u <
IF YOU NEED HELP PROGRAMMING THE TIMER, CALL TOLL FREE,
NUMBER 1-800-426-9345.
2
-
1
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line