Occurrence, Possible cmtse solution – FRIGIDAIRE Washer/Dryer User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OCCURRENCE
DRYER
POSSIBLE CMTSE
SOLUTION
Etyer does not start.
ËlectricalpDæroaniisrotæcumlyplLggBi
in or plug tray be loose.
r-bke sure the plugf its tightly inwall cutlet.
Huse fuseblomor cirmitbreakHr triiped.
Reset Cl m li
t.
breaker orrepl are fi tse.
№ke sure electrical line is not o\rer leaded and the
1
C5ptic^l^t"i=ir^‘i
TT^
1"I
t“
••..rUi i! Atp.jn.i.. CJ.l . V — t . »
Itemal lirtdter topped.
C&ll authorized service persen for r^lacatait.
Dryer
rune
but
won'
t
heat.
Iheœ are 2 hojse fuses Inthe dryer circuit.
If 1 of the2 fuses isblown, thedruriTnay
tumbut theheaterwill not cp)erate.
R^lacefuse.
Gassipplyvalveisnotcpeu (gasmodels).
Check to make sure supply valve is open. See
INSTALLATION INSTRUCTIONS for procedure.
Dryer does not have enouc^ air supply to
support the burner flaire (gas models) .
See INSTALLATION INSTRUCTIONS.
LP gas supply tank is errpty or there has
beenautility interruption of natural gas
(gasTTodels).
Refill orr^laietark.
Dryer should heat ^laiutility service is restored.
Drying
cycle
takes
too
Icng,
outsideof
thedryer
feels too hot or smells
hot.
Lint screai is closedvdthlint.
Make sure all lint has been ranoved from the dryer lint
scrraibefare startirg each cycle.
Exhaust duct requirements have not been
met.
Exhaust duct must be at least 4 inches in diarreter and
rradeof rigid or fladblenetal.
When in place, the duct must have no more than two 90°
bends and must not exceed length listed in INSTALIATiaSi
INSIRUCTIONS.
Electric dryer is connected toa 208 volt
dmit.
Drying time will be 20% longer than drying csia240 volt
ebnit.
Eaqdng procedures have not bear followed.
See Drying Procedures, page 10.
Outside esdiaust hood or eodiaust duct rrey
V-v-s
1 J.I.. .f. vii.i ■'^ ..E..C ..ifri.J »
dean out anyctetructicn.
High humidity.
Use a dehumi(±Lfier near the (dryer.
EMcessivevarinkHiig.
Dryer is overlcaded.
Donotoverlciad. See Drying Procedures, page 10.
Itansleft in dryer too lap.
Remove itans as soon as cycle ends.
Irojfficioit sortlrgof itetB.
See Drying Proceduires, page 10.
Drying taiperature too high.
Eollcwfahric care latel instruoticris.
1 5