Figure 1, Specifications & dimensions – Kenmore 625.3835 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Specifications & Dimensions
Model No. 625.383500
Model Code
350
Rated Softening Capacity (Grains @ Salt Dose)
12,600 @ 2.5 lbs.
26,900 @ 7.9 lbs.
32,100 @ 13.3 lbs.
Rated Efficiency (Grains/Pound of Salt @ Minimum Salt Dose)
5,090 @ 2.5 lbs.
Rated Service Flow Rate
8.0 gpm
Amount of Fligh Capacity Ion Exchange Resin
0.83 cu. ft.
Pressure Drop at Rated Service Flow
10 psig
Water Supply Max. Hardness
90 gpg
Water Supply Max. Clear Water Iron
11 ppm*
Water Pressure Limits (minimum / maximum)
20 - 125 psi
Water Temperature Limits (minimum / maximum)
40 - 120 °F
Minimum Water Supply Flow Rate
3 gpm
Intermittent Flow @ 15 psi
10 gpm**
Maximum Drain Flow Rate
2.0 gpm
*Capacity to reduce clear water iron is substantiated by WQA test data. State of Wisconsin
requires additional treatment if water supply contains clear water iron exceeding 5 ppm.
**lntermittent flow rate does not represent the maximum service flow rate used for detemi-
ning the softener’s rated capacity and efficiency. Continuous operation at flow rates
greater than the service flow rate may affect capacity and efficiency performance.
These systems conform to NSF/ANSI 44 for the specific performance claims as verified and
substantiated by test data.
The efficiency rating is only valid at the stated salt dose. These softeners were efficiency
rated according to NSF/ANSI Standard 44.
Variable Salt Dose: The salt dose is selected by the electronic controls at regeneration time
based on the amount needed.
Figure 1