Extra recharge, Recharge now, Recharge tonight – Kenmore 625.3835 User Manual
Page 15: Salt monitor system, Figure 24, Figure 22, Controller features, I j p, J‘ il, Figure 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Controller Features
EXTRA RECHARGE
Sometimes, a manually initiated recharge (regeneration)
may be desired, or needed. Two examples are:
• You have used more water than usual (guests visiting)
and you may run out of soft water before the next
automatic regeneration.
• You did not add salt to the softener before it ran out.
Add salt to the softener before regenerating.
You can start a regeneration immediately, or you can
set the controller to regenerate at the next preset
recharge time (2:00 AM, or as set).
RECHARGE NOW
Press the REGENERATION button and hold for 3 sec
onds. until the words “RECHARGE”, “Serv” and “Fill”
begin to flash in the display. The softener enters the fill
cycle of regeneration immediately. This regeneration
will take about 2 hours to complete. Then, you will
have soft water again.
NOTE:
If the “Clean Feature” is set ON, the normal
regeneration cycle is preceded by a cleaning
backwash and rinse. The words “CLEAN” and
“Bkwsh” or “Rinse” flash in the display, along
with the minutes of the clean cycle remaining.
/
8
Serv i
m
_}■
I J P«
6
J‘ IL
5
RECHARGE
Mi 4
M
3
'
t
■1 1
\ ““ ■
WATER FLOW
y
Figure 21
RECHARGE TONIGHT
Press and release (do not hold) the REGENERATION
button. “RECHARGE TONIGHT” will begin flashing in
the display, and the softener will begin regeneration at
the next preset recharge time (2:00 AM, or as set). If
you decide to cancel the regeneration before it starts,
press and release the RECHARGE button once more.
“RECHARGE TONIGHT” will stop flashing in the dis
play.
8
7
6
3-
J-
( J p M
IL
5
RECHARGE TONIGHT
MS
4
№ 3
■M
7
, SM'i -ks
WATER FLOW
SALT MONITOR SYSTEM
The water softener has a salt monitor indicator light to
remind you to add salt to the storage tank.
NOTE: You must set salt level each time salt is added
to the water softener.
NOTE:
The salt monitor system estimates salt levels, and
accuracy will vary with different salts.
To set this monitor system:
1. Lift the salt lid and level the salt in the storage tank.
2.
The yellow salt level decal, on the brinewell inside
the tank, has numbers from 0 to 8 (see Fig. 23).
Observe the highest number the leveled salt is at, or
closest to.
3.
Press the SET SALT LEVEL button as many times as
necessary to make the salt level bars in the display
(see Fig. 23) match the number on the decal. At
level 2 or below, the “Low Salt" indicator will flash.
4.
If you want to turn the salt monitor off, press the SET
SALT LEVEL button past 8, until “OFF” shows in the
display next to the number 8.
I J PU
J- IL
WmR FLOW
Figure 24
Figure 22
15