Optional settings, Salt efficiency, Clean feature – Kenmore 625.3835 User Manual
Page 16: Clean feature minutes, Maximum days between regenerations, 97% feature, 12/24 hour clock, Backwash & fast rinse times, Figure 25, Controller features
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Controller Features
OPTIONAL SETTINGS:
• SALT EFFICIENCY
• CLEAN FEATURE
• CLEAN FEATURE MINUTES
• MAXIMUM DAYS BETWEEN REGENERA
TIONS
• 97% FEATURE
• 1 2 / 2 4 HOUR CLOCK
• BACKWASH & FAST RINSE TIMES
1. To set any of these options, press and hold SELECT
for 3 seconds until “000” shows in the display. Then
press (do not hold) SELECT again to display one of
the “Salt Efficiency” screens shown below.
2.
Press SELECT again to display one of the “Clean”
screens shown below.
nrr
n
Ijrr
и 11
M
l
\ ^
.
.
Efficiency Icon
7^
Figure 25
SALT EFFICIENCY:
When this feature is ON, the
water softener will operate at salt efficiencies of
4000 grains of hardness per pound of salt or higher.
The softener may recharge more often using smaller
salt dosage and less water. This softener is shipped
with the efficiency feature set OFF.
Installations in
the State of California require this setting to be
turned ON.
Use the
A
UP or
V
DOWN buttons to
change between OFF and ON.
California Efficiency Requirement
Your Kenmore Water Softener has a “ffigh
Efficiency” feature that can be set ON or OFF.
This softener is shipped with the efficiency feature
set OFF, which will utilize the maximum rated
capacity while most often achieving maximum salt
efficiencies. When installing this unit in the State
of California, you MUST turn the efficiency feature
ON. The softener may initiate more frequent
recharges, but it will operate at 4000 grains per
pound of salt or higher.
Figure 26
CLEAN:
This feature is beneficial on water supplies
containing iron and/or high amounts of sediments
(sand, silt, dirt, etc.). When set to ON, a backwash
and fast rinse cycle will occur first, preceding the
normal regeneration sequence. This provides extra
cleaning of the resin bed before it is regenerated
with the salt brine. To conserve water, if your water
supply does not contain iron or sediments, be sure
this feature is set to OFF. The default is OFF. Use
the
A
UP or
V
DOWN buttons to change between
OFF and ON.
3. Press SELECT again to display the “Clean Time”
screen shown below.
3
1 MIN
CLEAN
TIME
\
Figure 27
CLEAN FEATURE MINUTES:
If you have set the
Clean Feature ON, the length of the extra backwash
cycle automatically is set to 2 minutes. Flowever, you
can adjust this time from 1 to 15 minutes in length.
To change this cycle time, use the
A
UP button to
increase the time, or the
V
DOWN button to short
en the time. If no change is desired, continue to next
step.
16