Kenmore 625.38811 - Manual (Page 10)

J J J J J J j :)
SECTION 2
j;j j:^.i.i J J j:^.i.i J J j :.
HOW YOUR WATER SOFTENER WORKS
A. FACEPLATE TIMER FEATURES
c
T
^ EXTRA RECHARGE
Sometimes, a manually started
regeneration (recharge) may be
desired, or needed. Two exam­
ples are:
- You have used more water than
usual (guests visiting) and you
may run out of soft water before
the next timer started regenera­
tion.
- You did not refill the softener
with salt before it was gone. After
you refill with salt:
You can start a regeneration right
away, or you can set the timer to
regenerate at the next 2:00 AM (or
other preset recharge time). Do
the following.
^ RECHARGE NOW
Press the RECHARGE button
and hold for 3 seconds. RE­
CHARGE NOW begins to flash
in the display, and the softener
enters the fill cycle of regeneration right away. This
regeneration will last for about 2 hours. Then, you
will have soft water again.
o
N
_ ||QP)W
RECHARGE HOW
^ RECHARGE TONIGHT
V PM
RECHARGE TONIGHT
Press and release (do not hold) the
RECHARGE
button. RE­
CHARGE TONIGHT flashes in
the display, and the softener be­
gins regeneration at the next preset recharge time.
Press and release the RECHARGE button once more
if you decide to cancel the regeneration, and RE­
CHARGE TONIGHT
^ PROGRAM MEMORY
If electrical power to the softener goes off, the time
display is blank but the face plate timer keeps the
correct time for about 6 hours. When electrical pow­
er comes on again, you have to reset the present
time only if the display is flashing. The HARDNESS
and RECHARGE TIME never require resetting un­
less a change is desired.Even if the timer is incorrect
after a long power outage, the softener works as it
should to keep your water soft. However, regenera­
tions may occur at the wrong time of day until you
reset the timer to the correct time of day.
^ ERROR CODE
An error code could appear in
the face plate display if a prob­
lem occurs in the softener elec­
tronics. If you see an error code
instead of the present time of day, turn to page 5-2
under "Troubleshooting" to resolve the problem.
err u \
IF YOU NEED HELP PROGRAMMING THE TIMER, CALL TOLL FREE,
NUMBER 1-800-426-9345.
2-1
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line