Cocoon POWERTALK 101 - Manual (Page 9)

PowerTALK 101
8
Ordering options
Default specifications for PowerTALK 101:
Power Supply:
230VAC
Network Connection: 10-BASE-T Ethernet
Serial Connectors: 2 off 9-pin D-type serial connectors,
Broadcast mode: UDP
The PowerTALK unit is marked at the back with the relevant information, including the standard
fixed IP address. See page 14 for
Device and terminal identification .
Custom specifications for PowerTALK 101:
The following options may be specified for PowerTALK 101 at time of order: At our discretion,
larger orders may justify more options than those stated below.
PT101 - 2 3 0 A - - 230 VAC isolated power supply
PT101 - 2 3 0 B - - Additional 10VDC output, ext. use
PT101 - 2 2 0 D - - 220 VDC isolated power supply
PT101 - 1 1 0 D - - 110 VDC isolated power supply
PT101 - E - - Additional 10VDC output, ext. use
PT101 - - 1 0 0 - Firmware version, eg. 1.00
PT101 - - - N No internal GPS clock
PT101 - - - A DB9, DB9 serial connections
PT101 - - - B DB-25, DB-25 serial connections
PT101 - - - 0 No on-board printer
PT101 - - - A RJ-45 10-Base-T
PT101 - - - B BNC 10-Base-2
PT101 Model number A,B, …
Available PowerTALK 101 models
101 UDP type IP protocols, broadcast mode
101B UDP type IP protocols, broadcast mode, peer to peer
101C TCP/IP type protocols, broadcast mode, peer to peer, packet numbering, error detection
Disclaimer
COCOON Creations cc cannot be held responsible for the ability or inability of operators and / or
software tools to manage specific devices properly. Neither can COCOON Creations cc be held
responsible for any network, carrier or equipment not performing as anticipated. COCOON
Creations cc can not be held responsible for any direct, indirect or subsequent damages or losses
due to the operation or lack there-of, of any device or software obtained from us.