Cocoon POWERTALK 101 - Manual (Page 32)

PowerTALK 101
31
PowerTALK 98 examples
Double clicking on a selected PowerTALK 101 unit on the main screen results in either of the
following screens to pop up. These screens may be used to set up both network and serial port
parameters.
Note the password must be set correctly for any change to take effect:
Change TCP/IP network configuration Change serial port details
•
A Password needs to be set according to
the password previously set on the PT unit
•
A New Password on the unit may be set
•
An arbitrary Host Name may be assigned
to a unit
•
A second IP address, Netmask &
Gateway may be configured as used in the
user network
A connected unit and port may be selected
Serial Port Settings such as baud rate, word
length, etc. may be changed
The port may be assigned to a channel
number, see p47 for details
The unit’s Buffer Settings may be changed. A
TCP/IP packet will be transmitted after a delay
time equivalent to the max. transmission time
of the specified number of bytes (at 10 bits per
byte at the current baud rate).