Extra recharge, Program memory, Error code – Kenmore 625.34847 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/665394/10/background.png)
SECTION 2
HOW YOUR WATER SOFTENER WORKS
2A.
face
plate
timer
features
EXTRA RECHARGE
Sometimes, a manually started regeneration (re
charge) may be desired, or needed- Two exam-
Д frl Д- Vw •
— You have used more water than usual (guests
visiting) and you may run out of soft water before
the next timer started regeneration.
— You did not refill the softener with salt before it
was gone.
You can start a regeneration right away, or you can
set the timer to regenerate at the next 2:00 AM (or
other preset recharge time), Do the following
RECHARGE
NOW
Ш
Press the ON/OFF---HOLD button and
hold
for 3 seconds
RECHARGE
NOW begins to flash in the
display, and the softener en
ters the fill cycle of regenera
tion right away This regeneration will last for
about 2 hours Then, you will have soft water
again-
RECHARGE
TONIGHT
H Press and release (do mot hold) die ON/
OFF-HOLD
button
RE
CHARGE TONIGHT flashes
in the display, and the soften
er begins regeneration at the
next preset recharge time. If you decide to can
cel the regeneration before it has started, press
and release the ON/OFF-HOID button once
more to turn off the flashing RECHARGE TO
NIGHT
3
“ ^3 I
RECHARGE NOW
PROGRAM MEMORY
If electrical power to the softener goes off, the
time display is blank but the face plate timer keeps
the correct time for about 6 hours. When electrical
power comes on again, you have to reset the
present time oaly if the display is flashing. The
HARDNESS and RECHARGE TIME never require
resetting unless a change is desired.
Even if the timer is inconect after a long power-
outage, the softener works as it should to keep
you water soft. However, regenerations may occur
at the wrong time of day until you reset the timer
to the correct time of day
ERROR CODE
An error code could appear in the face plate
display if a problem occurs in the softener
electronics. If you see an error code instead of the
lime of day, please call you local Sears Service
Department for service
Err
и i
IF YOU NEED HELP ON THE USE OF THE TIMER FEATURES, CALL TOLL FREE,
NUMBER 1-800™ 426-9345,
'
10