beautypg.com

Assembly instructions, Ignitor battery instaiiation - see fig. 3 – Kenmore 141.166801 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Assembly Instructions

CAUTION : White it is possible for one person to
remove the grill from the carton, it is recommended

that you obtain assistance because of the weight of
the grill.
1. Open the parts boxes. Use the parts list to check

that all parts have been included.

2. Inspect the grill for damage as you assemble it. Do

not assemble or operate the gnll if it spears
damaged. If there are damaged or missing parts

when you unpack the shipping box, or you have

questions during the assembly process, call:

1

-

888

-

317-7642

8 a.m. - 8 p.m CST, Mon. - Fri.

Installing Manual Lighting Stick

1. Attach the Manual Lighting Stick to the Left

Outside Bowl Panel as shown in Fig. 1.
Align the hole at the end of Manual Lighting
Stick Wire with the threaded hole on the Left
Outside Bowl Panel. Tighten securely using the
M4x8mm Phillips Head Screw.

Figure 1

H035 Qty. 1
M4x8mm Phillips Head Screw

Instaliing Side Shelf and Cart Side Handle

1. Remove the white protective film from the

stainless steel Side Shelf.

2. Enlisting ttie aid of an assistant, attach Side

Shelf to left side of grill. Align the holes on Side
Shelf with the threaded holes on left Outside Bowl
Panel. Tighten securely using 4 of the
1/4"x3/4" Phillips Screws provided.See Fig. 2.

H031 Qty. 4

1/4''x3/4" Phillips Head Screw

Enlisting the aid of an assistant, attach Cart Side
Handle to right side of grill. Align the holes on Cart
Side Handle with the threaded holes on right
Outside Bowl Panel. Tighten securely using 4 of

the 1/4"x3/4" Flat Head Screws provided.

See Fig. 2.

H034 Qty. 4
1/4''x3/4" Flat Head Screw

Ignitor Battery instaiiation - See Fig. 3

1. Unscrew the Ignitor Cap located on the grill

Control Panel and remove the Contact and
Spring from the Ignitor Slot.

2. Place the manufacturer supplied AA battery

into the Ignitor Slot. Be sure to place the
positive pole facing toward you. See Fig. 3

3. Place the Spring over the AA battery, then

place the Contact on top of the Spring. Screw

the Ignitor Cap back onto the grill Control

Panel.

4. Remove any protective film from outside and

inside of Grill Head.

Figure 2

SIDE SHELF-LEFT

GRILL HEAD

OUTSIDE BOWL
PANEL-RIGHT

CART SIDE
HANDLE

Figure 3

IMPORTANT: Before use of this grill please

refer to Cleaning Exterior Stainiess Steel

Surfaces found on page 18 of this Owner's

Manual.

11

This manual is related to the following products: