Kenmore 417.8413 - Manual (Page 10)

Operating Instructions
Cycle Options
Appropriate Options will automatically be displayed for each
cycle. The number of options selected will be displayed numeri­
cally on the Options button. Options can be added or deleted
before the cycle is started.
To adjust options, press the Options button to navigate to the
options screen. To add options, press the corresponding options
buttons. Selected options will be highlighted. To delete options,
press the corresponding options buttons again.
To protect your fabrics, not all options are available with every
cycle. If an option is not available with a particular cycle, it is
faded out. Occasionally, options in the same cycle will conflict
with each other, such as Soft Heat and Air Dry. When this hap­
pens, the option selected first will cause the conflicting option to
not be selectable. After you have made the desired adjustments,
press the Back button to return to the home screen or ► START
to begin the cycle.
E NOTE
To change the options after the cycle starts, press H! PAUSE and
then press the Cycle Settings button. Adjust the settings and
press ► START to resume the cycle.
Wrinkle Guard
Select Wrinkle Guard if the dried load might not be
removed promptly at the end of the cycle. The dry
load will continue tumbling without heat to help reduce
wrinkling. When Chime is selected, a beep will be heard
periodically. The load may be removed any time during
Wrinkle Guard.
Soft Heat
Select the Soft Heat option to protect a load from exces­
sive heat which can lead to shrinking and over-drying.
The drying temperature will be gradually reduced as the
load dries.
Add Steam
The Add Steam option injects steam into the clothing
prior to cool down to reduce wrinkling.
V NOTE
Steam may not necessarily be visible inside drum
during the Add Steam option.
It is not recommended to use fabric softener sheets
with Steam Cycles or Options as it may cause staining
on clothes.
Damp Dry Signal
For loads that contain some items you plan to hang dry,
flat dry or iron, add the Damp Dry Signal option to any
Auto Dry cycle. If the Chime is turned up, a chime will
sound when the load has reached the Damp Dry dryness
level to remind you to remove those items to hang dry,
dry flat or iron dry. Open the door, remove those items,
close the door and press the START button to continue
drying the remaining items.
Air Dry
This setting (no heat) can only be used with a Timed Dry
cycle to dry items containing feathers, down, foam rub­
ber, plastics or rubber-like materials; to refresh clothing,
stuffed animal, pillows or blankets; and to dust draperies.
10