Kenmore 116.35923 - Manual (Page 19)

LIGHT BULB REPLACEMENT
A WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
performing maintenance to the vacuum
cleaner. Failure to do so could result in
electrical shock or personal injury from
the vacuum cleaner suddenly starting.
TO REMOVE LIGHT BULB
1. Disconnect power cord from electrica!
outlet.
Flat
-^// 2. Press han-
screwdriver jj
die release
siots^y'H'^^ w pedal and lay
vacuum clean­
er back.
3. Pry light
lens out at
slots as shown
on both sides.
Rotate lens up
and lift off.
Headlight
Lens
A
CAUTION
Do not use a bulb rated over 9W (13V).
During extended use, heat from the
bulb could overheat surrounding plas­
tic parts.
4. Remove the light bulb
by pulling straight out.
5. To replace the light
bulb carefully insert
fully into slot.
Note: See PARTS AND FEATURES for
bulb number.
!lT
U
t :' -
M
A
CAUTION
Do not plug in or turn on until the vacu­
um cleaner is completely reassembled.
6
. To replace light
lens, place tab at front
of lens into slot. Rotate
lens down and firmly
snap into place.
DUST BAG COVER REPLACEMENT
Hinge Pin To reinstall or replace dust bag cover.
1. Align dust bag cover hinge pin with
hinge pin hole in dust container.
2 . Rotate dust bag cover into place.
3. You should hear a noticeable click
when hinge pin snaps into place.
19