Final installation checklist, Operation checklist, Installation of the – Kenmore 362.6278 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/665299/22/background.png)
INSTALLATION OF THE
11. Final Installation Checklist
• Check to make sure the circuit breaker is dosed
(RESET) or the circuit fuses are replaced.
• Be sure power is in service to the building.
• Check to be sure that all packing materials and tape
have been removed. This will include tape on metal
panel under control knobs (if applicable), adhesive tape,
wire ties, cardboard and protective plastic. Failure to
remove these materials could result in damage to the
appliance once the appliance has been turned on and
surfaces have heated.
• Check to make sure that the rear leveling leg is fully
inserted into the Anti-Tip bracket and that the bracket is
securely installed.
12. Operation Checklist
• Turn on one of the surface units to observe that the
element glows within 60 seconds,. Turn the unit off when
glow is detected. If the glow is not detected within the
time iimit, recheck the range wiring connections, if
change is required, retest again. If no change is
required, have building wiring checked for proper
connections and voltage.
• Check to make sure the Clock (on models so equipped)
display is energized. If a series of horizontal red lines
appear in the display, disconnect power immediately.
Recheck the range wiring connections. If change is
made to connections, retest again. If no change is
required, have building wiring checked for proper
connections and voltage. It is recommended that the
clock be changed If the red lines appear.
• Be sure all range controls are in the OFF position before
leaving the range..
Problem
Possible Causes
What To Do
Surface units
not functioning
properly
The surface units are not plugged
in solidly.
With the controls off, check to make sure the surface
unit is plugged completely into the receptacle.
The surface unit controls
are improperly set.
Check to see the correct control is set for the surface
unit you are using.
The drip pans are not set securely
in the cooktop.
With the controls off, check to make sure the drip pan is
in the recess in the cooktop and that the opening in the
pan lines up with the receptacle .
Oven iight does
not work
Light bulb Is loose or defective.
Tighten or replace the bulb.
Switch operating light is broken.
Call for service.
Oven wilt not work
Plug on range is not completely
inserted in the electrical outlet
Make sure electrical plug is plugged into a live, properly
grounded outlet.
A fuse in your home may be blown
or the circuit breaker tripped.
Replace fuse or reset circuit breaker.
Oven controls Improperly set.
See the Using the oven section.
Food does not bake
or roast properly
Oven controls improperly set.
See the Using the oven section.
Shelf position is incorrect or the
shelf is not level.
See the Using the oven section.
Incorrect cookware or cookware of
improper size being used.
See the Using the oven section
Oven thermostat needs adjustment.
See the Adjust the oven thermostat—Easy to do
yourself! section.
22