Kenmore 362.6278 - Manual (Page 18)

Ü? INSTALLATION OF THE RANGE
ELECTRICAL CONNECTIONS {coni)
3. Power Cord and Strain Relief Installation
a. Remove the wire cover {on the lower back of the
range) by removing two (2) screws using a 1/4" nut
driven
Do not discard these screws.
b. Remove the knockout ring (1%") located on bracket
directly below the terminal iDlock. To remove the
knockout, use a pair of pliers to bend the knockout ring
away from the bracket and twist until ring is removed.
c. For power cord installations only (see the next step
if using conduit), assemble the strain relief in the hole.
Insert the power cord through the strain relief and
tighten, Allow enough slack to easily attach the cord
terminals to the terminal block. If tabs are present at
the end of the winged strain relief, they can be
removed for better fit,
NOTE: Do not instali the power cord without a
strain relief. The strain relief bracket should be
installed before reinstalling the rear range wiring
cover.
Skip to Step 4 or 5.
d.For conduit installations only, purchase a squeeze
connector matching the diameter of your conduit and
assemble it in the hole, Insert the conduit through the
squeeze connector and tighten. Allow enough slack to
easily attach the wires to the terminal block,
NOTE: Do not install the conduit without a squeeze
connector. The squeeze connector should be installed
before reinstalling the rear range wiring cover.
Conduit Bracket
Skip to Step 6 or 7.
18