Kenmore INTELLISOFT 625.38376 - Manual (Page 7)

Plan Your Installation
outside faucet
FIG. 3
WHERE TO INSTALL THE WATER SOFTENER
Review the following points before you choose a place to put your softener.
1. Place as close as possible but always after, the
pressure tank (well water) or water meter (city
water). See Fig. 3.
2. Place as close as possible to a water drain such as
a floor drain, laundry tub, sump or standpipe. See
Fig. 3.
3. Connect to the house main water pipe BEFORE
TFIE WATER FIEATER. See Fig. 3. Temperature of
water going through the softener must not be
more than 120°F (49°C). Plot water will damage
inner softener parts.
To reduce the risk of hot water
backup, piping between the softener and water
heater should be as long of a run as possible.
4. Keep outside faucets on hard water to save soft
water and salt. See Fig. 3.
5. Do not install in a place where the softener could
freeze. Damage caused by freezing voids the war­
ranty by Sears, Roebuck and Co.
6. Put the softener in a place where water damage is
least likely to occur if it develops a leak. Sears or
the manufacturer will not repair or pay for water
damage.
7. A grounded, 120V electrical outlet is needed within
10 feet of the softener. See Fig. 3. This is to plug in
the transformer. The softener has a 10 foot power
cable. Be sure the outlet and transformer are in
an inside place, to protect from wet weather. Use
a continuously “live” outlet, which cannot be acci­
dentally switched off.
8. When installing in an outside location, you must take
the steps necessary to assure the softener, installa­
tion plumbing, and wiring, are protected from the
elements, contamination, vandalism, etc.
9. Keep the softener out of direct sunlight. The sun’s
heat can melt plastic parts.
Questions? Call The Kenmore Water Line 1-800-426-9345