Kenmore ELECTRIC RANGE 790.4660 - Manual (Page 40)

General Care & Cleaning (confd)
Removing and Replacing Warmer (Warm & Ready^”) Drawer
A WARNING
i
Electrical Shock Hazard can occur and result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmerdrawer.
To Remove Warmer Drawer:
A CAUTION ¡Turn power off before removing the warmerdrawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, puli up on the left glide lever
and push down on the right glide lever (See Figure 1).
4. Pull the drawer away from the range.
To Replace Warmer (Warm & Ready™) Drawer:
1 . Pull the bearing glides to the front of the chassis glide (See Figure 2).
2. Align the glide on each side of the drawer with the glide slots on the
range.
3. Push the drawer into the range until levers “click” (approximately 2”). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers “click” or the bearing glides do not feel seated
remove the drawer and repeat steps 1 thru 3. This will minimize
possible damage to the bearing glides.
NOTE: The Warmer Drawer will NOT operate while in the “Self-Clean” and “Oven
Lockout” modes
Figure 2
Changing the Oven Light
The oven lights will automatically turn ON when the oven door is opened. The
oven lights may also be manually operated by pressing the
O ven
LIGHT
O n /O ff
pad.
The lamp is covered with a glass shield. The glass shield can be removed to be
cleaned manually or to change oven light. THIS GLASS SHIELD MUST BE IN
PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
1
.
2
.
3.
4.
5.
6.
Turn the power off at the main source.
Wear a leather-faced glove for protection against possible broken glass.
To remove the glass shield, pull the back side of the shield toward the inside
of the oven in a manner to lift it up from the oven side.
The glass shield should come out easily by pushing a little toward front of
the range.
Replace halogen light appliance bulb taking care not to touch the bulb with
your bare fingers. Touching bulb with your skin can leave a film on the bulb
that causes it to burn out quickly.
Replace glass shield in opposite order and manner of removal.
and remove it. Halogen
Light Bulb
40