beautypg.com

Removing & replacing the oven door, General care & cleaning (cont’d) – Kenmore 790.7011 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

General Care & Cleaning (cont’d)

To Clean the Recessed and Contoured Areas of the Cooktop - If a spill
occurs on or In the recessed or contoured areas, blot up spill with an absorbent
cloth. Rinse with a clean, damp cloth and wipe dry.

To Remove and Replace the Surface Burner Caps and Surface Burner

Heads - Remove in the following order: (1 st) surface burner grate, (2nd) surface
burnercap and (3rd) surface burner heads.

Reverse the procedure above to replace the surface burner cap and surface burner
heads. Do not remove any parts from the cooktop until they have

completely cooled and are safe to handle. Do not operate the surface
burners without the surface burner cap and surface burner head properly
in place.

To Clean the Surface Burner Caps andSurface Burner Heads - Use a soap-
filled scouring pad or a mild abrasive cleanser to clean the surface burner caps
and surface burner heads. The ports (or slots) around the burner head must be
routinely cleaned. If residue still remains in these ports, use a small-gauge wire or
needle to clean the slots or holes. For proper flow of gas and ignition of the
burner—DO NOTALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY
OTHERMATERIALTOENTERTHEGASORIFICE HOLDEROPENING.
ALWAYS keep the surface burner cap and surface burnerhead in place whenever
a surface burner is in use.

Removing & Replacing the Oven Door

ikCAUTION

! The door is heavy. For safe, temporary storage, lay the door flat with

the inside of the door facing down.

To Remove Oven Door:

1. Open oven door completely (horizontal with floor - See Fig. 1).

2. Remove 2 screws located on the inside of the oven door liner (See A Fig. 2)
3. Insertthe 2 screws into the door hinge holes located on the side of the hinge arm,

one into each hinge (See B Fig. 2).

4. Close oven door until the door stops, (Do not force the door to close any further).

The placement of these screws should keep door open in about a 45 degree
position.

5. Grasp oven door firmly on both sidesand slide door up and off hinges at the same

angle. (See Fig. 3)

6

. Tociean oven door, follow the instructions in the General Care & Cleaning table.

To Replace Oven Door:

1. Be sure the hinge arms remain at the45 degree angle position. Be sure the screws

are still locking the hinge arms from moving. If the screws fall out of the hinge
holes, the hinge(s) may snap back against the oven frame and could pinch fingers
or chip the porcelain finish on the oven front frame.

2. Hold door at the sides near the top while resting the lower front of door on your

knee. Insert the door channels at the bottom of door over the door hinges, (See

Fig. 3).

3. Allow the door to slide down into the door hinges evenly at the same 45 degree

angle. The hingearms should be inserted into the bottom corners as far as they
can go.

4. Open door completely (horizontal with floor) and remove both screws from holes

in door hinges.

5. Reinstall the 2 screws into the door liner (See C Fig. 2).

6

. If the door is not in alignment with the oven frame, remove door and repeat the

above steps.

12

This manual is related to the following products: