Warning, Motor safety filter, Motor safety filter cleaning – Kenmore ASPIRADORA 116.35913 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO REPLACE DUST BIN LID
Replace dust bin lid assembly by placing
back on dust bin with marks on the lid
aligned as shown under 0|pen (For
Erupting) on the back of the dust bin.
Turn This Direction
To Close For Use
Open
Rotate clockwise while pressing downward
so marks align as shown above dosed
(For Use).
Insert dust bin
into cleaner.
Lower the dust
bin handle to
lock dust bin in
place.
A noticeable
“click" should
be heard.
Dust Bin
Handle
M
5Ssa®;iSii:Sias5i№»si
wm
11*11
A
WARNING
Electrical Shock Hazard
Unplug power cord from electrical out
let. Do not operate the vacuum clean
er without №e motor safety filter. Be
sure the filter Is diy and properly
installed to prevent motor failure and/or
electrical shock.
MOTOR SAFETY FILTER
Check motor safety filter frequently and clean
when dirty.
•Filter
Release
Handle
1. To remove motor safety filter lift filter
release handle upward and rotate the filter
cover out.
2. Remove filter by pressing on the sides of
the filter frame and pulling out at the same
time.
niter
Frame
Filter
Cover
Bottom
Tabs
3. Clean filter if necessary by placing it under
running water wait until dry before replacing.
4.
When putting the filter back into the filter
cover, listen for the filter assembly to snap
into place.
Note; Push only on frame, not filter itself.
5. Replace cover by fitting bottom tabs into
slots and rotating into compartment. Push
filter release handle down until you hear a
noticeable “click".
16