Warning, Primary filter, To replace primary filter – Kenmore ASPIRADORA 116.35913 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A
WARNING
Electiica) Shock And Personal Injury
Hazard
Unplug power cord from electrical out
let Do not operate the vacuum cleaner
without the primary or exhaust filters.
Be sure the filters are properly installed
to prevent motor failure and or eiectri-
ced shock.
PRIMARY FILTER
Check primary filler frequently and clean
when dirty.
TO REMOVE PRIMARY FILTER
Remove the dust bin assembly as outlined
in the DUST BIN CLEANING section.
Make sure dust bin is free of debris before
removing lid and filter. Rotate dust bin lid
assembly counterclockwise as indicated on
the lid and lift off.
Turn This Direction
To Open For Emptying
Closed
While holding dust bin lid over a trash con
tainer grasp primary filter, rotate counter
clockwise and lift off.
Clean primary filter by gently tapping over a
trash container. Tap on several sides to
ensure best cleaning.
Dust Bin
Lid
Cleaning
Cam
Filter
Remove primary
filter by turning
it counterclock
wise and pulling
out (See arrows
on bottom of fil
ter). Rinse with
water only as
needed, do not
use any deter
gent or soap.
Allow the filter to dry for 24 hours
before putting it back into the vacuum.
When cleaning the filter no longer
restores vacuum suction to full power you
need to replace the filter.
Note: See PARTS AND FEATURES
for the filter number.
TO REPLACE PRIMARY FILTER
To replace filter, insert it over cleaning
cams as far as it will go. Make sure rubber
seal at top of filter is flush against filter sup
porter, turn fitter clockwise to secure into
place.
Note: Under normal use and care, your fil
ter can be expected to last up to 5 years.
, Rubber
Cleaning seal-
Cams
Filter
Supporter
Dust Bin
Lid
Re-assemble dust bin lid to dust bin. Insert
into cleaner and secure with dust bin han
dle.
15