Kenmore ASPIRADORA 116.35913 - Manual (Page 14)

A
WARNING
Always unplug power cord from electri­
cal oufiet before performing any ser-
^rice on vacuum.
TO REMOVE DUST BIN
Lift dust bin handle located at the top of
the dust bin.
Dust Bin
Handls
Pull the handle up
and lift dust bin up
and out of the vac­
uum cleaner.
Dust
Bin
Remove any clogs that might be located in
the suction port or filter port area.
Sucfion Port
Filter Port
TO EMPTY DUST BIN
Before remowng debris from dust bin it is a
good idea to move the dust bin filter clean­
ing lever back and forth several times.
Dust Bin
Filter
Cleaning
Lever
Moving the lever
back and forth
loosens the dust
and debris that
has attached
itself to the filter
element inside
the dust bin.
Rotate dust bin handle to the vertical posi­
tion.
Hold dust bin
over a trash con­
tainer.
Press the dust
bin door release
button down­
ward to release
the door.
The door wilt
swing open and
the debris will
fall into the trash
container.
Dust Bin
Handle
Dust Bin
Door
Release
Button
Dust Bin
Emptying
Door
Shake the dust
bin to release
and debris that might hang in the filter ele­
ment.
Note; See PRIMARY FILTER REMOVAL
AND CLEANING section.
After the dust bin is
empty of debris,
firmly close the
door. Make sure
you hear a “click”
sound to indicate
that the door is fully
latched.
Door Door
Latch
TO REPLACE
DUST BIN
Place dust bin back
into vacuum cleaner
by inserting the bot­
tom first and tilting
back with the dust bin
handle raised.
Dust Bin
Handle
Lower the dust
bin handle to
lock dust bin in
place.
A noticeable
“click” should
be heard.
14