Kenmore 141.17337 - Manual (Page 23)

Install Grease Tray Kit
1. Place Heat Shield into Grease Draining Tray.
The Heat Shield must be present and
centered for your safety. From the back side
of Grill Head, install the Grease Draining Tray
with its drain hole to left, which is the side
opposite from the Tank Pull-Out Tray. See
Fig. 14.
2. From the front side of cabinet, open the front
doors and Install the Grease Receptacle under
Grease Draining Tray. See Fig. 14.
Figure 14
Congratuiations
Your Kenmore gas grill is now ready for use.
Before the first use and at the beginning of
each season (and whenever the LP gas tank
has been changed):
1. Read ail safety, lighting and operating
instructions.
2. Check Gas Valve Orifices, Burner Tubes
and Burner Ports for any obstructions.
3. Perform gas leak check according to
instructions found on page 23 of this
manual.
A
WARNING
A strong gas smell, or the hissing sound of
gas indicates a serious problem with your gas
grill or the LP gas tank. Failure to immedi­
ately follow the steps below could result in a
fire or explosion that could cause serious
bodily injury, death, or property damage.
• Shut off gas supply to the gas grill.
• Turn the Control Knobs to OFF position.
• Put out any flame with a proper fire extin­
guisher.
• Open Grill Lid.
• Get away from the LP gas tank.
• Do not try to fix the problem yourself.
• If odor continues or you have a fire you
cannot extinguish, call your fire department.
Do not call near the LP gas tank. Your
telephone is an electrical device and could
create a spark resulting in fire and/or explosion.
NOTE: The normal flow of gas through the
regulator and hose assembly can create a
humming noise. A low volume of noise is
normal and will not interfere with operation of
the grill. If humming noise is loud and exces­
sive you may need to purge air from the gas
line or reset the regulator excess gas flow
device. This purging procedure should be
done every time a new LP gas tank is
connected to your grill. For help call the
Customer Service Helpline.
Customer Service Helpline:
Bam - 8pm CST, Monday through Friday
1-888-317-7642
Checking For LP Gas Leaks
Never test for leaks with a flame. Prior to first
use, at the beginning of each season, or every
time your LP gas tank is changed, you must
check for gas leaks. Follow these four steps:
1. Make a soap solution by mixing one part liquid
detergent and one part water.
2. Turn the grill Control Knobs to the full OFF
position, then turn the gas ON at source.
3 . Apply the soap solution to all gas connections.
If bubbles appear in the solution the connec­
tions are not property sealed. Check each
fitting and tighten or repair as necessary.
4 . If you have a gas leak you cannot repair, turn
off gas at the source, disconnect fuel line from
your grill and call 1-800-4-MY-HOME® or your
gas supplier for repair assistance.
23