beautypg.com

Caution, Do not overtighten, Cord assembly – Kenmore 116.3172 User Manual

Page 6: Attachment, Assembly, Attachment assembly

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

A

CAUTION

Do not overtighten.

Overtightening could strip the screw
holes.

Do not operate the cleaner without

the screw In place.

Using a
screwdriver,
tighten the
screw

CORD ASSEMBLY

Make sure the quick release cord hook is in

the upright position Remove the wire tie
from the power cord.

lock the cord into
place by forcing it
into the locking
notch on the body
of the quick

release cord hook

as shown. This
helps keep the
power cord out
from under the
vacuum cleaner
agitator.

Power

Cord

Wrap the
power cord
around the
quick release
cord hook
and lower
cord retainer,
then lock the
power cord
plug onto the
power cord.

ATTACHMENT
ASSEMBLY

After the handle has been assembled to the

body and the power cord has been wrapped

around the cord hooks, the attachments can

be assembled.

1. Snap the suction inlet end of the hose
into the back of the vacuum cleaner.

2. Place the hose behind the handle and
over the hose holder.

3. Place the hose in the front slot of the
tool holder, twisting and pushing down over
the short hose to assure a good connection,

4. Place the extension wand in the rear slot
of the tool holder.

5. Slide the crevice tool into the slot beside
the wand.

6. Place the dusting brush or combination
brush on the wand with the brush portion

up.

Handle

Hose

1

Holder

Dusting
Brush

Extension

Wand

Crevice

Tool

This manual is related to the following products: