Assembly instructions, Warning, Ilectrical shock hazard – Kenmore 116.3172 User Manual
Page 5: Handle assembly, Assembly instructions -6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTIONS
Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List Use this list to verify that
you have received ail the components of
your new Kenmore vacuum.
A
WARNING
ilectrical Shock Hazard
Do not plug into the electrical sup
ply until the assembly is complete.
Failure to do so could result in elec
trical shock or infury.
HANDLE ASSEMBLY
Remove the screw located just below the
top edge of the back of the vacuum.
Position the handle as shown in the illustra
tion below.
While holding the power cord out of the way,
slide the handle into the opening at the top
of the vacuum.
Insert the screw so it passes through the
handle into the vacuum.
Begin to tighten the screw with your fingers.
It may be necessary to adjust the handle
slightly