Options, Start – GE EDWSO00 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ge.com

Options

The light above the selected pad will be ON to indicate which OPTION has been selected.

HOT START

(on some

models)

For use with heavily soiled and/or dried-on, baked-on soils. This option

MUST

selected

PRIOR

to starting the cycle.

This option will improve both wash and dry

performance. This option adds 20 minutes to the cycle time.

NOTE:

Cannot be selected with

RINSE ONLY

cycle.

HEATED DRY

Light OFF

Shuts off the drying heat option. Dishes air dry naturally and energy is saved.

For faster air dry you can prop the door open after the

CLEAN

light illuminates.

HEATED DRY

Light ON

Turns the heater on for fast drying. This will extend the total run time by 38 minutes.

NOTE:

Cannot be selected with

RINSE ONLY

cycle.

LOCK

(on some

models)

You can lock the controls to prevent any selections from being mode. Or you can lock
the controls after you have started a cycle.

Children cannot accidentally start dishwasher by touching pads with this option
selected.

To LOCK the dishwosher control,

touch and hold the

HEATED DRY

pad for 3 seconds. The light below

the

HEATED DRY

pad will turn on.

To UNLOCK the dishwasher control,

touch and hold the

HEATED

DRY

pad for 3 seconds. The

LOCK

light will turn off.

HOT WASH

When selected, the cycle will run longer with the heating element on to improve both

wash and dry performance,

NOTE:

Cannot be selected with

RINSE ONLY

cycle.

DELAY HOURS

You can delay the start of a wash cycle for 2, 4 or 8 hours (delay time options may

vary by model). Touch the

DELAY HOURS

pad to choose the number of hours you want

to delay the start of the cycle; then touch

START/RESET

one time. The dishwasher will

count down and start automatically at the correct time.

Touching

START/RESET

second time will cancel the

DELAY START

selection

U )

r-i-

1Л

RESET

To change a cycle after washing starts, touch the

START/RESET

pad to cancel the

cycle. The

START/RESET

light will flash while the water Is pumped out if needed. This

takes approximately 90 seconds. When the light stops flashing, the dishwasher can be

reprogrammed and restarted.

Start

Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the

START/RESET

pad once to begin the cycle. Water begins to fill the dishwasher, and approximately 60

seconds later the wash action begins. Touching the

START/RESET

pad a second time will cancel the

cycle and cause the water to drain out. This will take approximately

minutes.

NOTE:

The dishwasher remembers your last cycle so you don't have to reprogram each time. When

the dishwasher door is fully closed, the control panel lights will display the last settings you selected.

If you don't want to change any of the settings, simply touch the

START/RESET

pad once to begin

the cycle.

If the door is closed, the indicator lights will turn off if the

START/RESET

pad is not pressed within two

minutes. To activate the display, open and close the door or touch any pad.

Also, if a power failure occurs,

NORMAL

and

HEATED

DR/

will automatically be programmed.