GE 49-4562 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To replace hood lamp, first disconnect power at
main fuse or circuit breaker panel or puli plug.
Rernovs 2 screws from each side of lower panel atid
3 screws from front edge. Lower panel until it rests
on range below. Be sure bulb to be replaced is cool
before removing. Remove bulb or bulbs and replace
with 40 watt appliance bulbs. Raise lower panel and
wave oven.
alckr>triral nnwer tn mir;m-
WWIIIIWV wiwwfcf ivrw«!
To replace your oven lamp, first disconnect power at
main fuse or circuit breaker or pull plug. Remove the
top griii by taking off 2 screws which hold it in place.
Next, remove the single screw on top left that
secures lamp housing. (On models so equipped.)
Open oven door for easier removal of the lamp hous
ing assembly. Then grasp tab and pull out and up to
clear door hinge and front lip of oven. To remove
bulb, push it inward gently and turn to left, then pull
outward from socket. Replace with GE Lamp
«25T8DC.
Do not attempt to operate the oven unless the grill is
.in place.
Clean off the grease and dust on hood surfaces
often. Use a warm detergent solution. About 1 table
spoon of ammonia may be added tO the Water.
Take
care not to touch the filters and enameled surfaces
with this. Ammonia will tend to darken metal.