Replacing the light bulb, Cooktop light/nite light – GE CVM1790SSSS User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
GEAppliances.com
Plastic Color Panels
Use a clean, soft, lightly dampened cloth, then dry thoroughly.
Door Seal
It's important to keep the area clean where the door seals against the microwave. Use only mild,
non-obrosive detergents applied with a clean sponge or soft cloth. Rinse well.
Bottom
Clean off the grease and dust on the bottom often. Use a solution of warm water and detergent.
Replacing the light bulb.
1
Remove screw.
Cooktop Light/Nite Light
Replace with a 120 volt,
40
watt (mas.)
halogen bulb. Order WBOSHIOOSI from your
GE supplier.
Д To replace the cooktop light/nite light, first
disconnect the power at the main fuse or
circuit breaker panel, or pull the plug.
g Remove the screw from the side of the light
compartment cover and lower the cover
until it stops.
g Be sure the bulb is cool before removing.
Break the adhesive seal by gently
unscrewing the bulb.
g Screw in the new bulb, then raise the light
cover and replace the screw. Connect
electrical power to the oven.
27