Саге and cleaning, Replacing the surface light, Remaving and cleaning the filters – GE ZSA2201RSS User Manual
Page 35: Replacing the aven cavity lamp
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/664400/35/background.png)
Саге and Cleaning
Advantium Oven
Replacing the
surface light
1. To replace the surface light, first
disconnect the power at the main fuse
or circuit breaker panel.
2. Remove the screw from the side of
the light compartment cover and lower
the cover until it stops.
3. Be sure the bulb to be replaced is
cool before removing. Gently pull the
bulb from the receptacle.
Replace with a 130 volt, 50-watt
halogen bulb. Order WB08X10051
from your GE supplier.
4. Raise the light cover and replace
the screw. Connect electrical power to
the oven.
Remove screw
Remaving
and cleaning
the filters
1. The metal filters trap grease
released by foods on the cooktop.
They also prevent flames from
foods on the cooktop from
damaging the inside of the oven.
2. For this reason, the filters must
always be in place when the hood
is used. The vent filters should
be cleaned once a month, or as
needed.
3. To remove, slide them to the rear
using the tabs. Pull down and out.
4. To clean the vent filters, soak them
and then swish around in hot water
and detergent. Don't use ammonia
or ammonia products because
they will darken the metal. Light
brushing can be used to remove
embedded dirt.
5. Rinse, shake and let dry before
replacing.
5. To replace, slide the filters into the
frame slots on the back of each
opening. Press up and to the front
to lock into place.
Replacing the
aven cavity
lamp
1. Disconnect power at the main fuse
or circuit breaker panel.
2. Remove the top grill by removing
the two screws that hold it in place.
3. Remove charcoal filter if present.
Slide the filter toward the left and
pull toward the front to remove.
NOTE: Charcoal filter is an optional
kit, you may not have one.
4. Remove the screw holding the lamp
shield in place.
5. Pull the lamp shield out. Pull the
light bulb out and replace with a
120V-130V, 20 watt halogen bulb.
Order WB25X10019 from your GE
supplier.
5. Return the lamp and lamp shield to
original position and replace screw
and charcoal filter.
7. Replace the grill and 2 screws.
Reconnect power to the oven
35