Char-Broil 461111811 - Manual (Page 9)

HEAT RESISTANT SHIELD (G)
BOTTOM (H)
1/4-20 x 3/8” SCREW (M)
LEG (K)
Assembly
- Position Heat Shield (G) as shown at right below and place into
Bottom (H).
- Insert narrow end of Burner (F) through large hole in side of Bottom
(H) and rest burner bracket on Shield (G).
- Insert one 1/4-20 x 3/8” Screw (M) through Bottom (H), Shield (G)
and into burner bracket.
1
BURNER (F)
- Position Legs (K) as shown at right.
- Spread ends of Legs (K) slightly and insert into holes in front and
rear of Bottom (H).
2
9
CAUTION
Some parts may contain sharp edges! Wear protective
gloves if necessary.