Whirlpool ET25DQ - Manual (Page 5)

B E F O R E U S I N G Y O U R R E F R I G E R A T O R
Before Using Your
Refrigerator
In This Section
Page Page
Cleaning your refrigerator.......... ........... 5 Installing it properly.............. ................ 6
Plugging it in.............................. ........... 5 Leveling it............................. ................ 6
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it and level it.
Cleaning your refrigerator
Removing packaging materials
Remove tape and any inside labels (except
the model and serial number label) before
using the refrigerator.
To remove any remaining glue:
• Rub briskly with thumb to make a ball, then
remove.
OR
• Soak area with liquid hand-dishwashing
detergent before removing glue as de­
scribed above. Do not use sharp instru­
ments, nibbing alcohol, flammable fluids or
abrasive cleaners. These can damage the
material. See “Important Safety Instruc­
tions” on page 3.
NOTE: Do not remove any permanent
instruction labels inside your refrigerator. Do
not remove the Tech Sheet fastened under
the refrigerator at the front.
Cleaning it before use
After removing all packaging materials,
clean your refrigerator before using it, if
necessary. See cleaning instructions on
pages 21-22.
Plugging it in
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electrical
supply is r^uired. It is recommended that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.
See Electrical Requirements and Ground­
ing Instructions Sheet in your Literature
Package.
3-prong grounding
type wall receptacle
Refrigerator
power cord
3-prong
grounding
plug