Adjusting the crisper humidity control, Removing the freezer shelf, Using the automatic ice maker – Whirlpool ET25DQ User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
U S I N G Y O U R R E F R I G E R A T O R
Adjusting the crisper humidity control
You can control the amount of humidity in
the moisture-sealed crisper.
• Adjust the control to any setting between
LOW and HIGH.
• LOW (open) lets nxMst air out of the crisper
for best storage of fruits and vegetables
with skins.
• HIGH (closed) keeps moist air in the
crisper for best storage of fresh, leafy
vegetables.
Removing the freezer shelf
Remove the upp>er freezer shelf for easier
cleaning.
To remove the freezer shelf:
1. Lift front of shelf slightly.
2. Lift back off supports.
3. Replace in reverse order.
Using the automatic ice maker
Here are a few things you will want to know
about your ice maker.
• The ON/OFF lever is a wire signal arm.
DOWN to make ice automatically
UP to shut off the ice maker
IMPORTANT: Do not turn on the ice
maker until it is connected to the water
supply. Instructions for ice maker water
supply hook up are attached to the
back of the refrigerator cabinet.
• You may hear water running when the ice
maker is working. You’ll hear ice falling
into the bin. Don't let these sounds bother
you.
• If you remove the ice bin, raise the signal
arm to shut off the ice maker. When you
replace the bin, push it in all the way and
lower the ice maker signal arm to the ON
position.
UP to stop
Ice maker.
DOWN to
start ice
maker.
13