Solving common dispenser problems, Removing the base grille – Whirlpool ET25DQ User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
U S I N G Y O U R R E F R I G E R A T O R
Solving common dispenser problems
PROBLEM
CAUSE
SOLUTIONS
Ice dispenser
• Freezer door open
• Close the freezer door.
won’t work
* Ice bin not properly
installed
• Make sure bin is pushed in all the way.
• Wrong ice in bin
• Use only crescents from ice maker.
Shake the bin occasionally to keep cubes
separated and to obtain increased storage
capacity.
• Dispenser not used for
extended periods,
causing ice cubes to
melt together
• Dump old ice and make a new supply.
Ice dispenser
• Ice dispenser bar
• Wait about 3 minutes for the dispenser
stops working
held in too long
motor to reset.
• Large amounts of ice should be taken from
the bin, not through the dispenser.
Removing the base grille
To remove the grille:
1. Open refrigerator door.
2. Pull base grille forward to release the
support tabs from the metal clips.
3. Do not remove Tech Sheet fastened
behind the grille.
To replace the grille:
1. Line up grille support tabs with metal
clips.
2. Push firmly to snap into place.
3. Close refrigerator door.
See cleaning instructions for defrost pan and
condenser coils on page 22.
Condenser
coils
Metal clips
— Defrost pan Base
■ Support tabs grille
18