Adiustinc the oven temperature control, Locking, Screws – Whirlpool FGP315E User Manual
Page 12: Diustinc, Oven, Temperature, Control
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USINC VOUR RANCE
A
diustinc
the
oven
temperature
control
Although your new oven is properly adjusted to
provide accurate temperatures, it may cook faster
or slower than your old oven.
If you are not satisfied with the baking/roasting
results, you can change the temperature calibration
by following the steps below.
NOTE: DO NOT measure the oven temperature with
a thermometer. Opening the oven door will lower
the oven temperature and give you an incorrect
reading. Also, the thermometer temperature reading
will change as your oven cycles.
1. Make sure the oven temperature control knob is
turned to the off position. Pull the knob straight
off and flip it over.
2.
Loosen the locking screws inside the control knob.
Notches
Note the position of the notches.
Locking
screws
3.
Adjust the temperature.
• To lower the temperature, hold the knob
handle firmly and turn the skirt clockwise to
move the tooth a notch to the “G” on the
“COOLER” arrow.
• To raise the temperature, hold the knob
handle firmly and turn the skirt counterclock
wise to move the tooth a notch to the “G” on
the “HOTTER” arrow.
Each notch equals about 5°F.
To raise
Notches
To lower
Tooth
Skirt
4.
Tighten the locking screws and replace the
control knob.
Locking
screws
12