Selecting cyclesftemps, To select a different cycle/ temp, Fire hazard – Whirlpool 3396304 User Manual
Page 10: Press, You see, Warning, L^selectj
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
O P E R A T I N G Y O U R D R Y E R
Selecting cyclesftemps
Press ON/SELECT until the light glows by the
desired cycle. (The “presef selections are:
Perm Press-Med, Automatic Reg Dry with
Cycle Signal and FINISH GUARD* * Options
ON.)
To select a different cycle/
temp
Press ON/SELECT until the light glows by the
desired Cycle/Temp. Your dryer makes
selections for each Cycle/Temp. You can
change these selections if desired. See the
charts on pages 11 and 12 for the selection
you want to change.
^WARNING
Fire Hazard
Do not dry plastic or rubber items with
heat. Use the Fluff Air cycle, or line dry.
Failure to do so could result in fire or
damaged items.
YOU SEE
Cwtet/Twnpt Automatic-or- Tfcned
m
90 Mn
TO Mn
SO Mn
30 Mn
10 Ml
Options
•W-CyolsSlBnd
GuMd
Preset selections
PRESS
l^SelectJ
YOU SEE
Cydes/Temps
P
mii
P
immm
rf FUAlMtoM
TunMiPtMt-Mid
dDunpDtiMWi
j
NOTES:
• The last few minutes of all cycles are without
heat to make the load easier to handle.
• To help reduce wrinkling, remove the load from
the dryer as soon as tumbling stops. This is
important for permanent press, knits and
synthetic fabrics.
10