Whirlpool 940 - Manual (Page 16)

SETTING TNE CONTROLS
Understanding the status indicators
LOCK OUT
LOCK OUT
The LOCK OUT feature lets you lock out the
furwtion of the control
pads. When using LOCK
OUT, you cannot start
the dishwasher.
To use LOCK OUT:
• Press and hold AIR DRY (about 5 seconds)
until the LOCK OUT indicator glows.
WASHING
To turn off LOCK OUT:
• Press and hold AIR DRY (about 5 seconds)
until the LOCK OUT indicator turns off.
WASHING
The WASHING indicator glows at the start
of the first fill of any cycle
(except RINSE/WASH
LATER) and remains
on until the end of the
main wash.
WATER HEATING
The WATER HEATING indicator glows
whenever water is heated
during a cycle.
RINSING
The RINSING indicator glows during the
last two rinses of all
cycles.
DRYING
The DRYING indicator glows during the
drying portion of each
cycle - even if you select
AIR DRY. It turns off at
the end of the cycle. If
dishes are not as dry as you expected when
using AIR DRY, either allow tonger drying
times (overnight) or do not use AIR DRY.
CLEAN
The CLEAN indicator glows at the end of a
cycle to show that the
load is clean. All other
indicators turn off. The
CLEAN indicator glows
until you press CANCEL/DRAIN or any other
control pad.
WATER HEATING
16