Whirlpool 940 - Manual (Page 15)

SETTING THE CONTROLS
Adding a dish during a cycle
You can add an additional item to the
dishwasher anytime before the main wash
portion of a cycle. See chart on pages 12
and 13.
1. Lift up the door latch to stop the cycle.
Wait for spraying action to stop before
opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait
30 seconds for the air in the dishwasher
to warm up. Doing so reduces the
amount of moisture in the vent when
restarting a cycle.
4. Close the door firmly until it latches. The
dishwasher resumes the cycle.
Using the delay wash cycle
Use 4 HOUR DELAY START to run the
dishwasher during off-peak hours to reduce
energy usage or to reduce daytime heat
buildup in your home.
1. Close door firmly until it latches.
2. Press 4 HOUR DELAY START. The pad
indicator will glow red.
3. Press a Cycle pad. The DELAY START
countdown begins when you
press the Cycle pad. If you
don’t press a Cycle pad within
30 seconds, the DELAY
START indicator turns off.
4. If desired, press one or more Option pad(s).
The 4 HOUR DELAY START indicator stays
on until the wash cycle begins.
NOTES:
• Press 4 HOUR DELAY START anytime
during the delay period to start
dishwasher immediately.
• Press CANCEL/DRAIN to cancel the delay
B
cycle. The 4 HOUR DELAY
START indicator will turn
off. Press new Cycle and Option
pads.
• You can add items to the load anytime
during the delay countdown. After adding
Hems, close the door firmly until H latches.
The delay countdown will not continue if
the door is not latched.
15